Of course you can expand this scenario with more Vlans and more Layer 2 switches as needed.

conf t.

. In this tutorial you will learn how to configure trunk in switches.

#trunk #switch #cisco #packettracer.

Feb 14, 2020 · a.

Dynamic trunking protocol (DTP) manages the trunk links between Cisco switches. . .

.

. com. b.

On SW2: SW2 (config)#interface fastEthernet 0/1 SW2 (config-if)#switchport mode trunk. .

.

.

2. .

Switch (config-if)# switchport trunk allowed vlan 1,2,3,4. On S1, set F0/1 to negotiate trunk mode.

Jan 12, 2021 · Repeat the above steps on Switch B to configure the trunk ports that connect to the trunk ports configured on Switch A.
Create the subinterface G0/0.

Create the subinterface G0/0.

1Q.

Jan 12, 2021 · Repeat the above steps on Switch B to configure the trunk ports that connect to the trunk ports configured on Switch A. Configuring and operating an access port is more simple that a trunk port. .

1q frame tagging protocols, you also need to use the switchport trunk encapsulation {dot1q | isl} command to define the type of trunking. 0. . This video shows you the steps to configure a Trunk port between two Cisco Switches using Cisco Packet Tracer. . com.

To verify how the trunk port is configured you can issue few show.

com/. Apr 11, 2020 · fc-falcon">Configuration of a trunk link between Ethernet switches using Cisco Packet Tracer.

0.

In Cisco IOS Software, you can configure the VTP domain name, the VTP mode, and the VLANs in VLAN configuration mode.

Connection between a switch and a switch should have the ports trunked and have access ports between switch and host.

Select Router0 and Go to Physical.

.